G83 (Peck drilling problem)
I have a peck drilling problem (G83); while operating my Cincinnati Milacron Sabre 750 with 2100 Acrimatic controller;
Below are the lines of codes I ran on the VMC, the G83 code went rapid to the clearance plane, then stopped there. It did not go further to drill the programmed hole (I.e it didn't feed in the Z-direction as required).
:100 T15 M6; HSS-Cobalt I (0.272inch diameter drill, 135o point angle)
N10: G0 z1.0 M08
N20: G83 X3 Y0.3189 R0Z-1.6563 K0.125 J11 F0.7 S350 M03 W1
Please any help regarding this will be appreciated.
Below are the lines of codes I ran on the VMC, the G83 code went rapid to the clearance plane, then stopped there. It did not go further to drill the programmed hole (I.e it didn't feed in the Z-direction as required).
:100 T15 M6; HSS-Cobalt I (0.272inch diameter drill, 135o point angle)
N10: G0 z1.0 M08
N20: G83 X3 Y0.3189 R0Z-1.6563 K0.125 J11 F0.7 S350 M03 W1
Please any help regarding this will be appreciated.
Read more http://www.practicalmachinist.com/vb/cnc-machining/g83-peck-drilling-problem-241743/